SCP Man Page

NAME

scp - secure copy (remote file copy program)

SYNOPSIS

scp [-pqrvBC46] [-F ssh_config] [-S program] [-P port] [-c cipher]
[-i identity_file] [-o ssh_option] [[user@]host1:]file1 [...]
[[user@]host2:]file2

DESCRIPTION

scp copies files between hosts on a network. It uses ssh(1) for data transfer, and uses the same authentication and provides the same security as ssh(1). Unlike rcp, scp will ask for passwords or passphrases if they are needed for authentication.

Any file name may contain a host and user specification to indicate that the file is to be copied to/from that host. Copies between two remote hosts are permitted.

The options are as follows:

-c cipher
Selects the cipher to use for encrypting the data transfer. This option is directly passed to ssh(1).

-i identity_file
Selects the file from which the identity (private key) for RSA authentication is read. This option is directly passed to ssh(1).

-p Preserves modification times, access times, and modes from the original file.

-r Recursively copy entire directories.

-v Verbose mode. Causes scp and ssh(1) to print debugging messages about their progress. This is helpful in debugging connection, authentication, and configuration problems.

-B Selects batch mode (prevents asking for passwords or passphrases).

-q Disables the progress meter.

-C Compression enable. Passes the -C flag to ssh(1) to enable compression.

-F ssh_config
Specifies an alternative per-user configuration file for ssh. This option is directly passed to ssh(1).

-P port
Specifies the port to connect to on the remote host. Note that this option is written with a capital `P', because -p is already reserved for preserving the times and modes of the file in rcp.

-S program
Name of program to use for the encrypted connection. The program must understand ssh(1) options.

-o ssh_option
Can be used to pass options to ssh in the format used in the ssh(1) configuration file. This is useful for specifying options for which there is no separate scp command-line flag. For example, forcing the use of protocol version 1 is specified using scp -oProtocol=1.

-4 Forces scp to use IPv4 addresses only.

-6 Forces scp to use IPv6 addresses only.

DIAGNOSTICS

scp exits with 0 on success or >0 if an error occurred.

AUTHORS

Timo Rinne <tri@iki.fi> and Tatu Ylonen <ylo@cs.hut.fi>

HISTORY

scp is based on the rcp program in BSD source code from the Regents of the University of California.

SEE ALSO

sftp(1), ssh(1), ssh-add(1), ssh-agent(1), ssh-keygen(1)

Information Technology and Engineering Computer Services (ITECS)
College of Engineering, North Carolina State University, Raleigh, NC 27695
Comments to eoshelp@ncsu.edu. URL: http://www.eos.ncsu.edu/

This support page is for students, faculty, and
staff at North Carolina State University.